40" x 16"

Parts List 40” x 14” Table

Amount               Description

30                           #8 SS Flat Head Screws (Add 4 screws each for optional knife holders or leader holder)

2                              ¼” – 20 X 1 ¼” SS Hex Bolts

6                              ¼” SS Round Washers

4                              ¼” x 1” SS Carriage Bolts

4                              ¼” SS lock Washers

6                              ¼” – 20 SS Wing Nuts

2                              #8 x ¼” Pan Head Screws

20                           #8 x 7/8” Phil Pan SMS Screws

1                              Table Top Seaboard®

2                              Table Sides Seaboard®

1                              Table Back Seaboard®

2                              Knife Holders Seaboard®

1                              Gutting Tray Back Seaboard®

1                              Gutting Tray Front Seaboard®

2                              Gutting Tray Sides Seaboard®

1)      Fasten base mounts to the bottom side of tabletop with #8 x 7/8” SMS Screws. With the mounts having two sides, face the grooved side into the table and the open end to face the rear of table. This will form an elongated slot that allows the SS Carriage Bolt heads to slide in and hold them in place. Once the bolts are in, fasten the ¼” Pan Head Screws into the remaining pilot holes located just outside of the open end of the mount. This will keep the carriage bolts secure from sliding out.

2)      Fasten knife holders to R side with # 8 x 1” SS screws. Right side has plug cut herring slots cut into part. Face knife holder slots towards the front of the table. Knife holder slots are not machined through you must push your knife into the slots to cut through the .050” skin; this will give a nice tight form fit to the blade. The knife holders may also be attached to the back of your table in the provided holes, or additional knife holders may be purchased.

3)      Fasten left & right sides to table top with # 8 x 1” SS screws.

4)      Fasten back to table top and sides with # 8 x 1” SS screws.

5)      Set assembled parts aside.

6)      Fasten Scent Bottom to GT Back (32” x 13” tables and larger not applicable to 24” & smaller tables)

7)      Fasten GT Front to GT Back with # 8 x 1” SS screws. (Make sure front pockets are facing up)

8)      Fasten GT sides to GT Back & GT Front with # 8 x 1” SS screws. (Make sure hex cutout faces in)

9)      Install Gut Tray in table and tap the ¼” -20 X 1 ¼” hex bolt through hole lining up the hex with bolt head. The threaded portion of the bolt should protrude through the slot in the sides. Install a ¼” washer and wing nut.

10)  Turn table upside down install 2 - ¼” -20 x 1 ¼” carriage bolts into the mounting slots attach shaft mounts on carriage bolts with a round and lock washer with supplied ¼” – 20 SS nuts do not over tighten these nuts or you will damage the mounts and make the table fore and aft adjustment un-usable. Tighten the nuts just enough to collapse the lock washer.

11)  Enjoy the use of your table and feel free to send any action photos to MillerMarineProducts@gmail.com if you have any comments or questions give us a call @ 360-896-0481 or email.