Deluxe Bait Table

1)      Fasten the leader holder sides to the bottom of the table top with # 8 x 1” SS screws. The leader holder side that is not machined through will point inwards and can be installed on either side.

2)      Install knife holders to the left side with # 8 x 1” SS screws. Knife holder slots are not machined through you must push your knife into the slots to cut through the .050” skin; this will give a nice tight form fit to the blade.

3)      Fasten the scent holder top to the back using the upper holes with # 8 x 1” SS screws.

4)      Fasten sides and back to each other and the table top with # 8 x 1” SS screws.

5)      Attach the mounting shaft to the table top using the supplied ¼” – 20 x 1” SS hex bolts use a ¼” SS round washer and ¼” – 20 SS nylock nut.

6)      Install the aluminum tube axle and use the SS keeper pin to lock it in place. The leader holder can hold spools of line or a simple pre-tied leader holder foam tube made from pipe insulation and PVC pipe. One foam leader holder is included with a short length of PVC pipe feel free to purchase addition foam insulation from your local hardware store to make up as many leaders as you see fit.

Parts List

Amount     Description

18              #8 SS Flat Head Screws

2                ¼” – 20 X 1” SS Hex Bolts

2                ¼” SS Round Washers

2                ¼” – 20 SS Nylock Hex Nuts

1                Table Top Seaboard®

2                Table Sides Seaboard®

1                Table Back Seaboard®

2                Knife Holders Seaboard®

1                Scent/Pliers/Scissor Holder Seaboard®

2                Leader Holder Sides Seaboard®