Standard Bait

1)      Fasten knife holders to back with # 8 x 1” SS screws. Knife holder slots are not machined through you must push your knife into the slots to cut through the .050” skin; this will give a nice tight form fit to the blade.

2)      Fasten the pliers’ holder to the left side with # 8 x 1” SS screws.

3)      Fasten the sides and back to the top with # 8 x 1” SS screws.

4)      Fasten the mounting shaft to the table using ¼” – 20 x 1” SS hex bolts using the SS nylock nuts.

5)      The slots cut into the right side of the table are for plug cutting herring.

Parts List

Amount     Description

14              #8 SS Flat Head Screws

2                ¼” – 20 X 1” SS Hex Bolts

2                ¼” SS Round Washers

2                ¼” – 20 SS Nylock Hex Nuts

1                Table Top Seaboard®

2                Table Sides Seaboard®

1                Table Back Seaboard®

2                Knife Holders Seaboard®

1                Pliers/Scissor for Left side Seaboard®